Materials
Materials & finishes
Ander's Kraft wall art is cut from 16 gauge cold rolled steel, roughly 2mm thick, then powder coated and oven cured. Steel at this gauge stays rigid at 36 inches wide without a backing frame, holds laser-cut detail down to 2mm strokes, and carries an outdoor-rated finish that does not peel like paint.
Which finish should I choose?
| Finish | Look | Best for | Outdoor rated |
|---|---|---|---|
| Matte black | Flat, non-reflective black | Interior walls, modern and farmhouse rooms | Yes |
| Antique bronze | Warm brown with dark low points | Traditional entryways, brick exteriors | Yes |
| Brushed copper | Metallic copper with fine grain | Accent pieces, kitchens | Covered areas only |
| Weathered steel | Grey-brown patina effect | Rustic exteriors, cabins | Yes |
What sizes are available?
Most designs are offered from 12 to 36 inches wide. A 12 inch piece weighs about 0.6 kg and suits a gallery wall; 24 inches (about 2 kg) is the most ordered size and fills the space above a console table; 36 inches (about 4 kg) is sized for a fireplace or entry wall.
How does it mount?
- 1. Tape the included paper template to the wall and mark the pre-drilled hole points.
- 2. Drill 6mm holes and insert the supplied anchors for drywall, brick or siding.
- 3. Drive the screws until 3mm of thread remains, then hang the piece flush.
- 4. Optional ground stakes are available for address panels placed in a garden bed.
How do I care for it?
Wipe with a damp cloth and dry it; skip abrasive pads and solvent cleaners, which dull powder coat. Outdoors, rinse coastal salt spray off every few months. Powder coated steel installed under an eave typically holds its finish for 8 to 10 years.
Related pages
- How each piece is made in our workshop
- Frequently asked questions
- Shop address signs
- Shop decorative metal panels
- Returns and refunds
Last updated 30 August 2026.